International Science Community Association Research Journal of Engineering Sciences 2278 - 9472 5 8 2016 08 26 Study of Wire EDM with Low Frequency Vibration in AISI D2 Steel 8 13 EN Ashish* M.M. 1 Department of Electronics & Communication, Shri Shankaracharaya Group of Institutions, Shri Shankaracharaya Technical Campus, Junmani, Bhilai, Chhattisgarh, India G.R. Sinha 2 Shri Shankaracharaya Group of Institutions, Shri Shankaracharaya Technical Campus, Junmani, Bhilai, Chhattisgarh, India Sandeep Kumar 1 University Institute of Engineering and Technology, Rohtak, Haryana, India Sanjay Kumar 2 YMCA University of Science and Technology, Faridabad, Haryana, India Tarun* Saini 3 University Institute of Engineering and Technology, Rohtak, Haryana, India Sumit Kumar 4 University Institute of Engineering and Technology, Rohtak, Haryana, India Sumit Sabharwal 5 University Institute of Engineering and Technology, Rohtak, Haryana, India > Research Article 2016 7 26 2016 08 26 In this paper, we will study about the machining performance of Electrical Discharge Machining process with low frequency vibration. In this we will analyze the effect of low frequency vibration provided to the work piece which is taken as a main input factor with the parameters cutting speed and surface roughness of machine. This happened with the help of fixture and vibration actuator unit. By the help of this vibration unit vibration produced to the work piece, this vibration removed the debris fast and our cutting speed increased with increasing speed the surface roughness is minimized. The working range and levels for the WEDM parameters are studied by this survey. The Taguchi technique is used here to study the effects of the WEDM.. Copyright@ International Science Community Association